If the thief left a door opened, the alarm will sound for six 30 second cycles, remain armed and ignore that triggered zone. The alarm will continue to sound for 30 seconds, then stop and continue to monitor all protected entry points. Opening any protected door, hood or trunk lid will cause the alarm to immediately sound.If the siren did not sound when arming, then the chirps have been turned off and you should refer to the section titled “ELIMINATING THE ARM / DISARM CHIRPS“. At the end of the passive arming cycle: The dash mounted LED begins to flash slowly. Opening any protected entry point during the 30 second passive arming cycle will immediately suspend automatic arming and the 30 second passive arming cycle will re-start when all doors are closed.The dash mounted LED begins to flash rapidly, indicating 30 second passive arming has begun. Turn off the engine, exit the vehicle and close and lock all doors, hood lid and trunk lid.Press and hold the Lock/Arm button on the keychain transmitter for 2 seconds.ĪRMING THE SYSTEM - PASSIVE (AUTOMATIC) (Must be activated during programming):.Turn off the engine, exit the vehicle and close all doors, hood lid and trunk lid.SILENT ARMING - ACTIVE (Must be activated during programming):
Press and release Lock/Arm button on the keychain transmitter.Turn off the engine, exit the vehicle, and close all doors, hood lid and trunk lid.
Code alarm pro comp code#
Operating the Code Alarm PRO9801i Remote Start System
0 kommentar(er)
